An antique ring keeps a quiet record of its own age, if you know where to look. At Gatsby, we're antique jewellers. We spend our days handling, researching and dating rings like yours, and we almost never rely on a single clue.

We read several together: the marks inside the band, the metal, the way the stones are cut and held, and see where they agree. A hallmark with a date letter is the most precise evidence a ring can give, but not every antique ring has one. Without it, the other clues can usually still place a ring within a few decades.

This guide follows the order we use ourselves when a ring comes in: marks first, then metal, stones and setting, and finally the character of the piece as a whole. You can do all of it at home with a loupe, good light and a little patience.

What should you check first?

Start inside the band, where hallmarks sit. Hold the ring under a bright light, angle it until the marks catch, and use a 10x loupe if you have one. Read what's there before anything else. Our guide to reading antique jewellery hallmarks takes each mark in turn, but a few give you an answer straight away:

  • A date letter, matched to the right assay office's table, gives you the year the ring was assayed.

  • A 15ct or 625 mark means the ring was assayed between 1854 and 1932.

  • A 585 mark means it was assayed after 1932.

  • A small sovereign's head means it was assayed between 1784 and 1890.

It's important to remember that plenty of genuine antique rings carry no marks at all, either because they weren't required to or because a century of wear and resizing has taken them. Then the ring has to tell you its age in other ways. French marks are easy to spot, but they don't carry a date, so we have to judge the age ourselves.

So please don't fret if a ring you love has no hallmark. In antique and vintage jewellery it's actually far more common for a piece not to have one. An unmarked ring is also a clue in itself: UK rules on jewellery were relaxed until the Hallmarking Act 1973, so a ring with no UK marks is more likely to date from the early 1970s or earlier.

How can the metal help date a ring?

Metals go in and out of fashion, and a few arrived on a known date, which makes them a gift when you're trying to place a ring.

Gold. Gold carries the hallmark clues above. Until 1854 the official standards were 18ct and 22ct, and 9ct, 12ct and 15ct were added that year. A ring in 15ct is therefore unlikely to be Georgian, and a ring in 14ct was assayed after 1932.

Silver on gold. In Georgian and Victorian rings, diamonds were often set in silver on a gold mount, because silver kept the stones looking white. After a century or more, the silver can tarnish and darken, which is a small, honest sign of age.

Platinum. Platinum was hard to work until jewellers' torches improved, and it began replacing silver as the setting metal after the 1880s. Early platinum pieces were often backed with gold, and by about 1900 most important jewels were solid platinum. It's strong enough to hold stones in very fine mounts, which is what made the lacy settings of the Edwardian years possible.

War and metal. Platinum was reserved for armaments in the First World War and again in the 1940s, when palladium and white gold stood in for it. So a platinum ring is most likely Edwardian or Art Deco, while a white gold or palladium ring from the early 1940s tells the same wartime story.

What does the diamond's cut tell you?

Diamond cutting changed in recognisable steps, and an old stone is one of the most telling clues in a ring. Until the 1870s, cutters worked largely by hand. Then the bruting machine arrived, and stones became rounder and more regular.

Cut

Typical period

What to look for

Rose cut

From the 16th century; seen in Georgian and Victorian rings

Flat back, domed crown of triangular facets, no table or culet

Old mine cut

Early 18th to late 19th century

Squarish, cushion-like outline, small table, high crown, large open culet

Old European cut

Late Victorian to Art Deco

Round, small table, high crown, smaller culet

Transitional cut

Early to mid 1900s

Rounder and more regular than an old European, but not yet modern

Step cut (emerald, Asscher)

Asscher cut created in 1902; step cuts popular in Art Deco

Rectangular or square, with stepped facets and a quieter, layered light

Modern round brilliant

Close to its modern form by about 1940

Large table, thin girdle, no visible culet

Old mine and old European cuts both have 58 facets, like a modern brilliant, but the old stones were cut by eye. The facets are broader and the outline is slightly irregular. Instead of a fine, even sparkle, the light comes back in bold flashes of colour, which is much of their charm in soft light. Our guides to old cut diamonds, rose cut diamonds and antique cushion cut rings explain how each one behaves.

Two cautions, though. Stones travel: an old diamond can be re-set in a newer ring, so the cut tells you the stone's age more reliably than the ring's. And new stones can be cut in old styles, so an old-looking outline is a clue, not proof.

What can the setting and construction tell you?

Turn the ring over. The back of a ring tells you as much as the front.

  • Closed backs. Georgian stones usually sit in closed settings, sometimes lined with foil to deepen the colour or add sparkle. You can't see through the back of the stone.

  • Open backs. From the Victorian years settings began to open at the back, so light enters from underneath.

  • Hand finish. Georgian metalwork is handmade and can look a little rough around the edges. Through the Victorian years, manufacturing moved from the workshop bench toward larger-scale production, and pieces became more uniform.

  • Pierced and beaded work. Fine saw-piercing, filigree and millegrain, the tiny beaded edge around a stone, belong to the Edwardian years, when platinum made them practical.

  • Geometry. Straight lines, stepped profiles, knife-edge bands and precisely set baguette stones point to Art Deco.

  • Bulk. Domed, densely set bombé shapes and large cocktail rings point to the 1940s.

Does the ring look as old as it claims?

A century of wear leaves its marks, and we rather like them. Edges soften, engraving blurs, claws round off, and the underside of a shank thins where it has rested against a hand. These small signs of a long life are usually reassuring. Very crisp edges, sharp tool marks or a bright, uniform shine can mean a ring has been recently polished or reworked, which is worth asking about.

Which period does your ring belong to?

Each period had its own habits, and together they add up to a look you begin to recognise. Here are the main ones, in order.

Georgian rings (1714–1837)

Georgian rings are mostly silver and gold, handmade, with closed-back settings and rose cut, table cut or early old mine cut diamonds. The stones glow rather than flash, and they look their best in soft, warm light. Rings were sentimental: hands clasped, hands holding a flower, acrostic rings that spell a word with the first letter of each stone, and mourning rings in black enamel, with a portrait inside the band. Much Georgian gold carries no marks. Our guide to Georgian jewellery goes further.

Victorian rings (1837–1901)

Victorian rings are usually gold, with diamonds in silver-topped settings. Old mine and old European cuts are common, and the cutting grew more regular as the century went on. This is the age of the cluster, the solitaire and the crossover ring, and of symbolic motifs such as the serpent, which stands for eternity. Coloured gemstones such as sapphires, garnets and amethysts became more popular in engagement rings, and jet became fashionable after Queen Victoria went into mourning. Platinum only appears at the very end. Read more in our guide to Victorian jewellery and our guide to antique cluster engagement rings.

Edwardian rings (1901 to the First World War)

Platinum changes everything. Edwardian rings are typically platinum, or gold with a platinum front, and the strength of the metal allowed saw-piercing, filigree and millegrain so fine that the stones seem to float on knife-edge wires. Diamonds and pearls dominate, and the cutting is more regular, close to the modern round brilliant by about 1910. The look is light and lacy: ribbons, bows, garlands and hearts. Our guide to Edwardian jewellery has more.

Art Deco rings (1920s and 1930s)

Art Deco rings are architectural. Platinum or white gold, geometric outlines, symmetry and stepped profiles replace the softer florals of the years before. Stones are often step cut, baguette cut or calibre cut, and diamonds are frequently paired with deep blue sapphire, emerald, ruby or black onyx. Look for knife-edge bands, mirrored shoulders and the confidence of straight lines. Our guide to Art Deco jewellery explains the style.

Retro rings (late 1930s to the 1940s)

Wartime shortages shaped Retro jewellery, and you can feel it in the hand. Gold dominates, in thick, generous forms that made the most of the metal, because platinum was diverted to the war effort. Rings are bold: bombé and domed shapes densely set with small stones, and large cocktail rings in citrine, aquamarine, amethyst and topaz. They have a warmth and swagger that the cooler Deco years don't. Our guide to Retro jewellery tells the story.

The periods at a glance

Period

Dates

Typical metal

Typical diamond cuts

Setting and style

Georgian

1714–1837

Silver and gold

Rose, table, early old mine

Closed back, foil, handmade

Victorian

1837–1901

Gold, silver-topped on gold

Old mine, old European, rose

Clusters, solitaires, crossover; backs begin to open

Edwardian

1901 to the First World War

Platinum, or platinum on gold

Old European, early brilliants

Filigree, millegrain, garlands

Art Deco

1920s–1930s

Platinum, white gold

Step, baguette, calibre, brilliant

Geometric, symmetrical, knife-edge

Retro

Late 1930s–1940s

Gold

Small diamonds, pavé, coloured stones

Bombé, cocktail, chunky


Why is it hard to give a ring one exact date?

Because rings live long, busy lives. A ring may have been resized, repaired or re-set, and a stone may have moved from an older mount to a newer one, so a Georgian diamond can sit in a Victorian setting. The date letter tells you when the metal was assayed, not necessarily when every part of the ring was made. Some rings were also made in an earlier style long after its period had passed.

That's why we tend to say "late Victorian" or "around 1910", not a single year. It's the honest answer, and in a ring that's been loved for a century or more, the story of its changes is part of the charm.

What can you check at home?

  1. Look inside the band with a loupe for any marks, and note the assay office, the fineness and any date letter.

  2. Turn the ring over. Is the setting closed or open at the back?

  3. Look straight down into the diamond. A visible circle at its centre is an open culet, a mark of old cuts.

  4. Note the metal's colour and weight. Is it white, yellow or rose, and does it feel fine and light or thick and chunky?

  5. Look at the style as a whole. Is it floral and lacy, strictly geometric, or bold and domed?

Jot down what you see. Even without a hallmark, three or four of these clues pointing the same way is a good sign.

Who can tell you for certain?

A specialist antique jeweller or a qualified gemmologist can examine the ring in person, which is far more reliable than photographs. If the ring has an older London hallmark, the Goldsmiths' Company can help you trace it. And if you'd like to see these clues in the flesh, our antique and vintage rings are a good place to compare how the metal, cut and setting change from one era to the next.

Further reading

×